• 800-292-6137
  • We stock the largest selection of black & white and color film in the country.

Adox Labtime Mini Darkroom Timer

Currently Unavailable
#42540
Mfg: Adox
Notify Me.

If you would like to be notified when this item is back in stock, please enter your email address below.

The ADOX LABTIME MINI can count up as well as down.

You can measure the time which elapses until an event occurs (COUNT-UP) or let a time chose prior to count down (TIMER) in order to stop a process when the countdown is over. On the right hand side the three functions can be reached by moving the main switch to CLOCK, COUNT-UP or TIMER. All three processes can be run simultaneously, you can switch between them. If a process is active, the symbol will light up on the LCD screen. In the TIMER mode you can save the time chosen with MEMORY in order to repeat the countdown over and over. In order to repeat a countdown you need to push three buttons only: STOP (stops the old countdown), MEMORY (operates the set back time to the memorized time) and START in order to start the new countdown. The four rubber feet on the backside of the LABTIME MINI make sure you can operate this with one hand only. When a countdown is finished an alarm will sound and an optical indicator will show (TIMES UP will be displayed). The LABTIME MINI will not stop at zero but rather start counting up in order to indicate the overshot amount of time in case you don't hear the alarm at first and come back too late to your project. The alarm can be set dead on the backside of the LABTIME MINI if your processes are noise sensitive. The COUNT-UP function can be started by pressing START/STOP in COUNT-UP mode. With a second push on the START/STOP button the time is taken. Reset the stop clock with CLEAR to 0:0:00. The time is indicated in AP/PM format. When an alarm is ringing it can be stopped by pushing START/STOP. Set time: Push START/STOP in clock mode for about 2 seconds and the time will start blinking. Set the time with HR and MIN (check for AM or PM). Save the time by pushing START/STOP again. If you do not set a time the clock will automatically start running again after a few seconds.

Features

  • Stopclock function: Measure the time it takes from 0:00:00 until 23:59:59 with 1 second accuracy. START/STOP CLEAR.
  • TIMER-function: Count down a preset time. At the end an alarm will sound and an optical signal will show. Set back to the preset time with MEMORY.

Display

  • MEMORY (for Timer)
  • COUNTUP (Stopclock active)
  • TIMER (TIMER active)

Main switch to access

  • CLOCK
  • COUNT-UP
  • TIMER

Keyboard upper line 

  • HR (sets hours) 
  • MIN (sets minutes) 
  • SEC (sets seconds)

​Keyboard lower line

  • START/STOP
  • MEMORY (memorizes time) • 
  • CLEAR (reset to 0:00:00)

*Uses Varta MS76 SR44 G13 V76PX 1.55 volt Silver Oxide Battery, battery sold separately*

EAN: 6954213820297
You might also like